FLX Retrofit (1-sided)

All-Fiberglass Split Retrofit Fitting For Flexible Pipe

The FLX-Series Retrofits are your solution to entry boot failures where you have flexible pipe. They permanently Retrofit (not repair) flexible entry boots from inside a sump without breaking concrete, disconnecting the pipe or causing station downtime. Click this to read more

The key to the FLX-Series fittings is that you are making only epoxy or adhesive bonds between all materials: the sump, the fitting components and the pipe. How is that? We specify pipe-specific adhesives and use an FRP sleeve to essentially convert a short length of the pipe exterior to Fiberglass. Similar to our Retrofit-S fittings, the FLX-Series are kitted to include nearly everything needed to install them in one part number like gloves, sandpaper, emery strip, retrofit adhesive, the main split fitting which bonds to flat sump walls, a split adapter for curved sump walls and a split sleeve adapter sized for the flex pipe. The adhesive for bonding the sleeve adapter to the pipe must be purchased separately. To support the FLX line we are providing a “Flexible Pipe Identification Chart” (available below) to help you both identify the specific pipe you have in the ground and also the corresponding adhesive type you must order. These are compatible with all conventional and alternative fuels.
However, there are some caveats so pay attention: These are not for poly sumps, or newly installed flex pipe. The pipe must be “existing” and “mature”, that is: done with most or all of it’s growing. If the pipe has been installed for 3+ years, it qualifies.

Want to stop costly pump-downs, fines, maintenance and endless replacement of flexible fittings? Install the last one with a Bravo retrofit
For SingleWall Fiberglass sumps only - Flat or round walls
The Bravo Zero Leak Standard is a science. FLX fittings are bonded by fuel-resistant epoxy and pipe-specific adhesives
Never before could you say Dry Sumps together with Flexible Pipe. Well.. you can as soon as you install one of these
Get rid of flexible entry boots, nuts/bolts, clamps, metal and failures once and for all
Typical of a Bravo Retrofit, there's no need to break concrete OR disconnect any pipe lines
For various brands of flexible pipe with Polyethylene, Nylon or PVDV exteriors
Slide 1
Slide 1
  • Made in the USA (i)
  • FRP Construction / Built like a Tank (i)
  • Compatible with all fuels (i)
  • For mature flex pipe with Poly, Nylon or PVDF exteriors
  • Single split design with conversion sleeve
  • Additional flange for curved sumps included
  • Accommodates 0-20° of pipe angle by default
  • NO failure-prone materials or components
  • Kitted: Includes installation accessories (i)
  • Includes fiberglass epoxy
  • Third Party Approved