B-1000 DoubleWall VPH UDC
A: Bravo recommends an approved single-point hydro-static sensor, such as the two common sensor models below for monitoring Bravo brand DoubleWall containment sumps. Veeder Root part number: 794380-304 — Click Here to view product page. Franklin Fueling part no: TSP-UHS …
NO. Bravo’s stance on this is that because dispensers are not made air/water tight there needs to be open air where the concrete meets the paneling for the purpose of water drainage. There are several ways that water can enter …
All-Fiberglass Split Retrofit Fitting For Flexible Pipe
In regards to penetrations through the bottom of a 8600 series Above ground / Marina containment sump, this should not be done on a floating dock or a dock that will be in motion for the purpose of environmental protection …
A: Yes. Because the interstitial fluid is an integral part of the VPH system and DoubleWall sump, it is considered tampering if someone not certified is adding fluid, and/or if any fluid other than Bravo brand Interstitial Fluid is added …
No. The Bravo Conversion Frame (DCF) was developed to contain and control falling fuel spilled from a filter replacement, or small incremental leaks within the hydraulic cabinet area of a dispenser only. This area that we targeted when we started …
B-7000 Standard Split SingleWall UDC
Water-tight Retrofit SNAP-LOCK submersible cover
All-Fiberglass Retrofit Manway Cover
B-1000 SingleWall UDC
Yes. Bravo permits this in any State if the following conditions are met: > The sump must be installed by a DoubleWall Certified Bravo Installer. > The sump wall may not be modified in any way or opened to the …